jlaird
Great Pumpkin
Offline
you guys may have seen this before?
Has anyone else had this prob? I just came back from a nice drive, lovely here sun out and high 60s.
Here is what I determined.
Below 3K RPM all is fine. From 3K to 4K clutch pedel is low but workable when shifting. Above 4K pedel will not release clutch.
I do have a 1275 slave push rod which is 2 11/16 long vs the 948, 1098 which is 2 1/2 inchs long. However, I would think that the longer one would be fine as the pedel is good other wise. But then is it? I can change out easly enough, not a problem. Do you think it makes any difference?
Has anyone else had this prob? I just came back from a nice drive, lovely here sun out and high 60s.
Here is what I determined.
Below 3K RPM all is fine. From 3K to 4K clutch pedel is low but workable when shifting. Above 4K pedel will not release clutch.
I do have a 1275 slave push rod which is 2 11/16 long vs the 948, 1098 which is 2 1/2 inchs long. However, I would think that the longer one would be fine as the pedel is good other wise. But then is it? I can change out easly enough, not a problem. Do you think it makes any difference?