Offline
In order to remove the intake and exhaust manifolds to access to repair the broken exhaust pipe for cylinders 1 and 4 I had to undo the throttle linkage. Stupidly I did not diagram how everything was oriented prior to disassembly and I am having difficulty getting the linkage back together. Specifically, I need to know how the bell crank mounts:
1. Does its acute angle (less than 180 degrees) face up or down when the bellcrank is mounted on the post?
2. Is the spacer/bushing that is attached to the bellcrank facing inboard (towards the block) or outboard when the unit is slipped over the post?
Also, to what does the long throttle-return spring hook?
TIA....
1. Does its acute angle (less than 180 degrees) face up or down when the bellcrank is mounted on the post?
2. Is the spacer/bushing that is attached to the bellcrank facing inboard (towards the block) or outboard when the unit is slipped over the post?
Also, to what does the long throttle-return spring hook?
TIA....