Offline
Hello All,
I'm starting re-assembly of a TR4 engine, and have a couple questions about thrust washers. The standard thickness is .092", but I'm measuring .054" of endplay without any washers installed. Do I buy standard thickness washers and shave nearly half their thickness, or buy +.008" washers and only put one side in? Does there need to be washers on both sides of the bearing cap for proper wear?
Thanks, Phil
I'm starting re-assembly of a TR4 engine, and have a couple questions about thrust washers. The standard thickness is .092", but I'm measuring .054" of endplay without any washers installed. Do I buy standard thickness washers and shave nearly half their thickness, or buy +.008" washers and only put one side in? Does there need to be washers on both sides of the bearing cap for proper wear?
Thanks, Phil