Hello;
Purchased the above Burlen part number EPK 12EN to convert points to solid state. Got it assembled and running as per the instructions and tested getting about 3 PSI and it did not take long to fill a 12 oz. soda can!
Trouble is the pump runs does not stop as the points setup did when the float chambers are full. Not sure if this is typical & might need more adjustment.
I tried calling Burlen but they are closed until the new year hence my inquiry on this forum.
Thanks in advance,
Andrew
Purchased the above Burlen part number EPK 12EN to convert points to solid state. Got it assembled and running as per the instructions and tested getting about 3 PSI and it did not take long to fill a 12 oz. soda can!
Trouble is the pump runs does not stop as the points setup did when the float chambers are full. Not sure if this is typical & might need more adjustment.
I tried calling Burlen but they are closed until the new year hence my inquiry on this forum.
Thanks in advance,
Andrew