Just put wheels on my TR (frame only with motor, trans and rear end mounted) after front suspension rework and all went together great. However the rebound stop on the right side has clearance from the bracket under the shock but the left side (drivers side) doesn't. The tire contacts the garage floor but to make clearance between the stop and the bracket I have to jack the suspension up a good 1" maybe a little more and in so doing, raises the tire off the ground. I know everything has to settle and driving will accomplish that but it seems odd that both sides don't start out the same. I've thoroughly gone over every inch of the suspension and all is as it's suppose to be so can't figure out how to correct it unless I shave the rubber stop down a bit which I really don't wanna do.
I'm stumped..any thoughts on what's going on?...Thanks
Actually am I thinking backwards and maybe the bracket is suppose to rest on the stop and it's the side with the gap that needs to settle?
I'm stumped..any thoughts on what's going on?...Thanks
Actually am I thinking backwards and maybe the bracket is suppose to rest on the stop and it's the side with the gap that needs to settle?
Last edited: