I have about a 3/4” difference on the pass side of my scuttle which is enough that it causes the windshield to slope down on the pass side , it is noticeable when looking at the front end dead on. The rear deck is perfectly even. I took some measurements and it appears that the dimension from the floor to the tip of where the scuttle ends on the side of the vehicle, (by the uppermost top of the door). I was thinking of taking the outer sill off, raising the portion of the body tub just back to the forward mounting bracket of the inner sill. I was thinking of doing this with the door attached to make sure I can still get a good fit. I am open to suggestions as to how to approach this problem.