Hey there Guest!
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
Folks,
Section D.8 of the BMC shop manual notes that the carburetors float adjustment should be by use of a 7/16-inch diameter rod. This is for H4 carburetors.
Section DDD.6 notes that the float height should be adjured using a 5/16-inch diameter rod for 3000 Mk. II cars (HS4 carburetors.)
There is no mention on the float height for the original 3000 cars (BT7 and BN7)using HD6 carburetors.
What is the general view on float height for HD6 carbs?
Thanks.
Ron
Section D.8 of the BMC shop manual notes that the carburetors float adjustment should be by use of a 7/16-inch diameter rod. This is for H4 carburetors.
Section DDD.6 notes that the float height should be adjured using a 5/16-inch diameter rod for 3000 Mk. II cars (HS4 carburetors.)
There is no mention on the float height for the original 3000 cars (BT7 and BN7)using HD6 carburetors.
What is the general view on float height for HD6 carbs?
Thanks.
Ron
A friendly reminder - be careful what links you click on here. If a link is posted by someone you don't know, or the URL looks fishy, DON'T CLICK. Spammers sometimes post links that lead to sites that can infect your computer, so be mindful what you click.