• The Roadster Factory Recovery Fund - Friends, as you may have heard, The Roadster Factory, a respected British Car Parts business in PA, suffered a total loss in a fire on Christmas Day. Read about it, discuss or ask questions >> HERE. The Triumph Register of America is sponsoring a fund raiser to help TRF get back on their feet. If you can help, vist >> their GoFundMe page.
  • Hey there Guest!
    If you enjoy BCF and find our forum a useful resource, if you appreciate not having ads pop up all over the place and you want to ensure we can stay online - Please consider supporting with an "optional" low-cost annual subscription.
    **Upgrade Now**
    (PS: Subscribers don't see this UGLY banner)
Tips
Tips

Looking for suggestions - ignition issue

catfood

Jedi Knight
Offline
Hi folks,

I'm hoping someone might be able to suggest where to look first with an igniiton issue I have just encountered.

My BN1 has been converted to negative earth, has an alternator and CSI distributor.

I was tweaking the carbs and everything seemed to be running smoothly at tickover. I switched off the ignition while I looked for my carb balancer. When I restarted it the tickover was really rough and it struggled to keep running. Applying the accelerator had no effect. I switched the ignition off to check everything over and went back to restart it and it was the same. I switched the ignition off and the engine carried on running. I had to block the carbs to stall it. At his point I noticed the ignition light was still on even with the key was removed. I tried turning the power off at the boot (trunk) switch and the ignition light was still on. In the end I had to disconnect the battery to switch it off.

So any one encountered this before. Any suggestions?

Cheers

Steve
 

NutmegCT

Great Pumpkin
Gold
Online
To what's left of my brain cells, I'm thinking you have a dodgy wiring connection at the ignition switch. One wire just barely making contact, and probably jiggling on and off the point it should be firmly attached to.

Just a thought.
Tom M.
 

dklawson

Yoda
Offline
I thought those boot mounted switches removed all power from the car. Are there brown wire circuits that bypass the boot switch?

The charge indicator light remaining on and continued running is typically a symptom of one of two faults. You probably have a bad ignition switch as mentioned above or you have a failure inside the alternator. Most auto parts stores will bench test alternators for free.
 

RAC68

Darth Vader
Offline
Hi Steve,

I am really surprised at the number of things you have done to cut power to the ignition. When turning the battery ground switch off, you should be cutting all power to the electrical system in the car. However, if the car is running and the alternator is generating power, you may be pypassing the battery and running on the alternator... especially in the case where you are using the original voltage regulator as a switching point in the conversion and the alternator's regulator to control output power. Your charge light is light glowing inconsistently as an indication of inconsistent power being supplied.

Have you installed any additional fuses (in-line or block)? You may have had a failure in the alternator's regulator that is providing erratic power to your systems. I would pull the alternator and have it checked as this would be the easiest thing to do. Next, I would look to the wires in the start circuit including coil and ignition and starter switch lines.

Hope this helps,
Ray(64BJ8P1)
 
OP
catfood

catfood

Jedi Knight
Offline
Thanks for all the suggestions however I've (partially) solved the problem. The level of my stupidity sometimes knows no bounds. One thing I didn't mention that I checked when it wouldn't start first time was the fuses. Looking at them again tonight I had put one of the fuses back in the gap between the two fuses hence shorting everything instead of its correct place which seemed to be the cause of the novel ignition issues I had (perhaps I need a visit to the optician). So the car started and ran OK tonight but then exhibited the same restarting issues as before (without the ignition light and fail to stop with the key issue). I'm guessing I have a fuel vapourisation issue or the fuel pump isn't up to the job although I can hear it clicking but thats a job I think for the weekend.

Steve
 
Similar threads
Thread starter Title Forum Replies Date
2billydavies TR2/3/3A looking for suggestions on putting engine back in Triumph 17
Zimmycobra Trans problem. Looking for suggestions. Triumph 10
Patrick67BJ8 Wanted Looking for a used BJ8 switch panel. Austin Healey Classifieds 5
B Looking to buy Toyota Avensis T25, any thoughts and advice? Other Cars 1
AngliaGT Anyone Looking for a '28 Buick Drive Train for FREE? Other Cars 0
jfarris Looking for service options for a 2016 Lexus NX300h in Tyson's Corner VA Other Cars 0
T TR2/3/3A Looking for a TR3A front bumper Triumph 6
E TR6 looking for info on doing a T5 swap Triumph 5
E Wanted looking for a tr6 bell housing Triumph Classifieds 12
BJ8Healeys Location of VIN tag, 1964 Sprite HAN8L43421 (I know it's stamped on the frame. Looking for the tag.) Spridgets 8
T Looking for "BillMs rear transmission mount" Spridgets 2
R Wanted Looking For A Rear Glass For A Bugeye Hardtop Spridgets Classified 0
Racer-X- Looking for old parts catalog(ue)s with listings/part numbers for early 1960s Vanden Plas 4 Litre Princess Restoration & Tools 3
V Wanted Looking for SU HIF4 Linkages. MG Classifieds 0
Got_All_4 TR6 2nd Gear Bush Problem TR6 Looking at Steel Triumph 12
JPSmit A fairly specific looking bolt Spridgets 10
Celtic 77 MGB Looking for best info regarding throttle cable replacement. MG 16
R Wanted Looking for an original AH 3000 Mk1 Drivers Manual 1102B. Austin Healey Classifieds 1
D Wedge Looking for British Car Day Events Triumph 2
T Looking for recommendations re using a Seacan for vehicle storage Spridgets 7
BJ8Healeys Looking for BJ8 VIN HBJ8L40768 Austin Healey 0
M Wanted Looking for genuine Austin-Healey bonnet badge Austin Healey Classifieds 1
M Looking for Lucas parts catalogue British Motor Corp 13
tj_tr3_tr6 TR4/4A looking for Machine Shop TR4 Valve Job Ventura - Los Angeles area Triumph 4
idlehands GT6 What gotchas when looking for a GT6+ Triumph 10
BillyB62 TR2/3/3A Looking for the Owner of a TR3 Triumph 5
Got_All_4 Wedge Looking at a Local TR8 For Sale Little Ruff Triumph 1
F TR2/3/3A looking for door latch review Triumph 7
roscoe The future is looking up Austin Healey 4
Joel Lester TR2/3/3A Looking for helpful hints for door hinge screw removal Triumph 17
DrEntropy Looking thru old pix Other Cars 8
T 1972 MGB GT for sale in San Francisco, looking for a good home MG Classifieds 1
vping T-Series Looking for TD Part # MG 3
T Wanted Looking for a solid [but doesn't have to be perfect] 100-6 Austin Healey Classifieds 17
F GT6 Looking to sell - in progress restoration Triumph 19
Lin Looking for a part Spridgets 1
Lin MGB MGB and MGC - looking for a part MG 1
H Wanted Looking for TR4A intake # 307455 Triumph Classifieds 3
Y Wanted Looking for running 3.5L MK V engine Jaguar Classifieds 0
steveg TR6 Newbie looking for hopup guidance Triumph 15
Guido36 Looking for upholsterer recommendation for Healey 100 in Southern California Austin Healey 5
SherpaPilot TR6 Looking For Opinions on Seat Covers Triumph 9
S Wanted Looking for a new/used crankshaft for a 100-4 Austin Healey Classifieds 0
R TR6 Looking for Oil Filler Cap TR4/TR6 Triumph 7
pbraun Looking for 64 or 65 Mokes British Motor Corp 0
T Looking for a temporary cup holder - but my heart is pure Spridgets 9
angelfj1 TR2/3/3A Possible UK Source for Authentic looking Clutch/Brake MC Triumph 5
W Looking for engine rebuilding 100-6 Austin Healey 12
C Looking for SoCal restoration shop Austin Healey 4
R GT6 Looking to purchase GT6 Rust repair question? Triumph 4

Similar threads

Top