Simmo
Jedi Hopeful
Offline
There are three screws just behind the bell housing which bear on a spring and ball to put tension on the operating Rods.
Does anyone know how to manover the gearbox into a position in order to remove these bolts so that I can increase the tension on these springs with the introduction of a spacer.
At least one anyway, so as to hopefully stop the jumping out of top gear.
Any suggestions gratefully accepted
Does anyone know how to manover the gearbox into a position in order to remove these bolts so that I can increase the tension on these springs with the introduction of a spacer.
At least one anyway, so as to hopefully stop the jumping out of top gear.
Any suggestions gratefully accepted