This is a "Honeybourne" top.
Can some one that either has the same top or a factory fitted top, please post some pics of this area, and/or advise on how they managed the gaps.
Thinking PO may have trimmed down the steel section thus shortening it and worsening the gap.
Particularly interested on the position/angle of the the rear capping section that covers the top of the rubber door seal.
I still have to attach rubber seals to the underside of the top to seal the door glass, so not too worried about that area just yet.
Can some one that either has the same top or a factory fitted top, please post some pics of this area, and/or advise on how they managed the gaps.
Thinking PO may have trimmed down the steel section thus shortening it and worsening the gap.
Particularly interested on the position/angle of the the rear capping section that covers the top of the rubber door seal.
I still have to attach rubber seals to the underside of the top to seal the door glass, so not too worried about that area just yet.