Is this the correct speedometer drive "pinion & bearing" assembly for an A-type overdrive type 61374? It was in the overdrive when I bought it and I am assuming it is correct.
The other question I have, if this is the correct pinion & bearing assembly, what oil seal(s) and/or "O" ring(s) are used on it. The only seal I believe that is currently on it is some sort of rubber seal down inside the hole of the round bearing. I can't see it very well and the only reference I have found for a seal is Moss p/n 520-015 shown under #97 on the overdrive page of the Moss TR3/4 catalog. I'm getting transmission oil into the speedo cable so I believe that seal is letting oil seep past the pinion.
Thanks for the help!
Bob
The other question I have, if this is the correct pinion & bearing assembly, what oil seal(s) and/or "O" ring(s) are used on it. The only seal I believe that is currently on it is some sort of rubber seal down inside the hole of the round bearing. I can't see it very well and the only reference I have found for a seal is Moss p/n 520-015 shown under #97 on the overdrive page of the Moss TR3/4 catalog. I'm getting transmission oil into the speedo cable so I believe that seal is letting oil seep past the pinion.
Thanks for the help!
Bob