Offline
This shows the back of the seat frame, at the bottom edge, where the seat cover attaches:
There are two "lips" of metal running along the bottom. One takes clips for the rear of the cover, and the other for the front.
My front seat cover ( the pleated section) appears to be too long by about 3/4 to 1" in order for it to properly clip on.
Only solution I see is to re-stitch it about that much higher to make it tight enough. Make sense? Any suggestions from those in the know about fitment of these covers?
Do these seats appear original? I am not sure about that. Thought they are, but do not know. First bugeye I have done.
Appreciate your looking and any ideas !!!!!!!!!
There are two "lips" of metal running along the bottom. One takes clips for the rear of the cover, and the other for the front.
My front seat cover ( the pleated section) appears to be too long by about 3/4 to 1" in order for it to properly clip on.
Only solution I see is to re-stitch it about that much higher to make it tight enough. Make sense? Any suggestions from those in the know about fitment of these covers?
Do these seats appear original? I am not sure about that. Thought they are, but do not know. First bugeye I have done.
Appreciate your looking and any ideas !!!!!!!!!