Hallo there,

I am rebuilding my TR3As engine and found leckage in the cylinder head between the water side and the cylinder 2 exhaust channel- some crack inside the head. So probably hard or impossible to repair - No big thing, just leaking little water onto the exhaust valve an limiting the water level....

As this head already had some cracks repaired I would prefer to discard it now.

So apart from finding some used head and rebuild it the alternative is the cylinder head produced by Moss - Has anybody out there some experience with using this head?
I would go for the cast iron version, not the Aluminium one and the goal is to get a reliable engine for fast motoring, not racing.

Thanks in advance

Johannes - TS27952 LO