Getting ahead of myself here but I wanted to ask what others had done to support the frame/Motor and transmission assembly at a good working height to work on the body.
At the moment the frame is on saw horses but I am sure they would not hold the combined weight of the motor etc. and I think it would be too high.
I need to redo some of the body work the PO did as the driver side door will not fit. I think when he replaced the floor and inner sill he did not check the gap before welding it in place.
Am thinking of building a lower stronger saw horse arrangement.
David
At the moment the frame is on saw horses but I am sure they would not hold the combined weight of the motor etc. and I think it would be too high.
I need to redo some of the body work the PO did as the driver side door will not fit. I think when he replaced the floor and inner sill he did not check the gap before welding it in place.
Am thinking of building a lower stronger saw horse arrangement.
David