this car has been undergoing restoration for years. finally got it running and driving a few months ago, and ran into numerous problems. note: i had mistakenly paid somebody to do most of the work, and he decided he didn't want to finish it. most likely, he did such a lousy job he didn't want to be responsible for fixing the crap he did wrong. anyway, the transmission leaked so badly we had to pull it after putting about 7 miles on it. there was also a shifting problem, and we had to pull it to be sure there wasn't a problem with the clutch fork. anyway, we have tried twice to put it back in but can't get it home. it goes in far enough that it sits on the three top studs, but we can't get it any farther in.
i will also note that the alignment tool is hard to insert all the way too, like the tolerances are too tight.
thoughts/recommendations/direction?
thanks!
i will also note that the alignment tool is hard to insert all the way too, like the tolerances are too tight.
thoughts/recommendations/direction?
thanks!