Results 1 to 3 of 3

Thread: Header Rail Assembly

Discussions of Triumph motor cars

  1. #1
    Jedi Trainee
    Join Date
    Nov 2009
    Location
    Steamboat Springs,Co.
    Posts
    232
    Thanks Thanks Given 
    0
    Thanks Thanks Received 
    0
    Thanked in
    0 Posts

    Header Rail Assembly

    About to put the header rail onto the frame.
    Is the correct method sliding the rubber seal thru the channels prior
    to riveting onto the frame ? Working from the center channel outward.
    Any other secrets ?
    Thanks everyone
    Harry

  2. #2
    Luke Skywalker trrdster2000's Avatar
    Join Date
    Sep 2004
    Location
    Salisbury NC
    Posts
    1,820
    Thanks Thanks Given 
    12
    Thanks Thanks Received 
    9
    Thanked in
    9 Posts

    Re: Header Rail Assembly

    Harry, Pop rivet the channels on first and then just stuff the rubber seal in with a spatula that you use for putting body putty on and cut it too a couple of inches, it makes it easy with a little Vaseline on the rubber.

    Wayne
    '37 MG TA, '49 Triumph Roadster, '70 TR6, 2000 Jaguar XK8, '78 Spit6

  3. #3
    Jedi Trainee
    Join Date
    Nov 2009
    Location
    Steamboat Springs,Co.
    Posts
    232
    Thanks Thanks Given 
    0
    Thanks Thanks Received 
    0
    Thanked in
    0 Posts

    Re: Header Rail Assembly

    Thanks for the reply Wayne. Forgot to ask which side of the rubber goes outwards . The short side?

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •