Search:

Type: Posts; User: Tomblin; Keyword(s):

Search: Search took 0.00 seconds.

  1. Re: Ignition warning light remains on and headlights come on

    I hadn't messed with the control box either, so it was a bit of an education to try this. I thought about pitching the control box and buying a new one, but actually the one I had was fairly new....
  2. Re: Ignition warning light remains on and headlights come on

    OK, the problem is solved - I think. The basic problem was that the voltage regulator was allowing the voltage from the generator to be way too high. This caused the warning light to be on while...
  3. Re: Ignition warning light remains on and headlights come on

    Ray

    Thanks for your thoughts. With regard to the warning light and possible grounding of the white wire running to the ignition switch, I'll need to go check this and get back with you.
    ...
  4. Ignition warning light remains on and headlights come on

    Recently, I needed to rebuild the engine in my BJ8 and therefore took advantage of this to upgrade the wiring. Following the advice of several posters on this site, I modified the headlight circuits...
  5. Replies
    3
    Views
    603

    Re: Speedometer doesn't return to 0

    Thanks Bob. I did tap the face with no success. Also, I did make sure to install that washer on the angle drive. I suspect that it is something internal to the Speedo. I'll pull it and see if I...
  6. Replies
    3
    Views
    603

    Speedometer doesn't return to 0

    I am finishing up a 7 year refurbishment of my BJ8. When I started the project, the Speedo needle would bounce around and often just drop to 0. I have replaced the angle gear and cable. The car is...
Results 1 to 6 of 6