Search:

Type: Posts; User: DavidApp; Keyword(s):

Page 1 of 113 1 2 3 4

Search: Search took 0.04 seconds.

  1. Replies
    2
    Views
    35

    Re: We all should be dead

    :encouragement:
  2. Replies
    4
    Views
    57

    TR2/3/3A Re: tr3 spare tire fit

    I think it is the rubber trim that is holding it. If I remember correctly I may have had to trim the rubber to get mine to fit. I did struggle to get it to fit well.
    Also do you have the rubber...
  3. Replies
    26
    Views
    674

    Re: Our County has just abandoned recycling.

    Some of the cartons use to have a window pre perforated but that seems to have been discontinued now. I will try the do it your self window on the next pack.

    Seem to remember a scandal in the...
  4. Replies
    1
    Views
    31

    Re: 2 1960 3000 BT7's So Cal

    Hello heckstur

    Welcome to the forum.

    Post a few photos of your BT7's

    The AH section will be a great section to get tips and advice with the restoration. The Pub is an area where almost...
  5. Thread: New Guy

    by DavidApp
    Replies
    6
    Views
    84

    Re: New Guy

    Hello Carver

    I was going to say The Roadster Factory or Rimmer Brothers but I notice both do not seem to carry AH parts.
    There is a company in Australia that does steel parts and they do AH...
  6. Replies
    26
    Views
    674

    Re: Our County has just abandoned recycling.

    You can get cut on them as you struggle to get the item out of the package. I hate the packages of AA and AAA batteries. There is no way to get a few batteries out of the package without destroying...
  7. Replies
    17
    Views
    487

    TR2/3/3A Re: OD cover plate gasket sealer.

    Hello Graham

    I do recall having to fiddle the spring over the steel peg as I tightened the bolts but don't remember seeing the tube sticking up that far.

    I have a drip tray under the car and...
  8. Replies
    12
    Views
    242

    Re: Expanding the skill set

    A lot of good common sense ideas.

    I use the paper in the socket trick a lot. Had not thought of super glue for the washers.

    David
  9. Replies
    17
    Views
    617

    TR2/3/3A Re: Clutch through out fork misaligned

    I did the smaller diameter bolt.

    Having contacted TRF about this problem Albert got back to me and said they were looking into it.
    Great service from TRF.
    Thank you.

    David
  10. Replies
    17
    Views
    487

    TR2/3/3A Re: OD cover plate gasket sealer.

    I noticed that on the older version of the cover plate there it has a box type structure around the lower part of the solenoid and lever. Could this be adding to the strength of the cover and...
  11. Replies
    6
    Views
    126

    Re: Drive Your Triumph day photos.

    The Ocmulgee Historic National park or Ocmulgee Indian mounds as it use to be known as is a great park. Schools go there for field trips, it is a very good place to walk and in September there is a 3...
  12. Thread: New Member

    by DavidApp
    Replies
    1
    Views
    49

    Re: New Member

    Hello Mark

    Welcome to the forum.

    You will find that the Triumph section is very active so you are sure to get plenty of help and advice there for your Spitfire project.

    Post some photos of...
  13. Replies
    6
    Views
    126

    Re: Drive Your Triumph day photos.

    Thank you.

    Did a longer drive on Saturday about 70 miles each way. It was very cold but did warm up later.

    On our way back.

    David
    62266
  14. Replies
    6
    Views
    126

    Drive Your Triumph day photos.

    I took my TR3A out for a short run on Drive your Triumph day to a local National park. Ocmulgee Historic National park.

    It was a nice day for February not too cold and not raining.

    David
    ...
  15. Replies
    5
    Views
    122

    Re: GM killing off the Holden

    I rented a car while I was in Australia a lot of years ago. My Sisters father in law said "I see you have a Kangaroo Yank Tank" It was a Holden Commodore.

    Did a lot of miles in it but when I went...
  16. Thread: New Guy

    by DavidApp
    Replies
    6
    Views
    84

    Re: New Guy

    Hello Carver

    Welcome to the forum.

    That is a great find.

    The AH section will be a great help on your way to back to it being a driver.

    David
  17. Re: New member and proud (gulp) new owner of 1973 Triumph TR6

    Looking good.
    A very detailed setup.

    You will get good advice if you post this in the Triumph section. I am sure others have been through the same exercise.

    David
  18. Replies
    4
    Views
    123

    On our way back from a Saturday drive

    The car club had our meeting at a members shop for a change of venue. On our way home a couple of us stopped for gas.Service was real slow but I am sure they would have ethanol free gas.
    62240...
  19. Replies
    5
    Views
    209

    TR2/3/3A Re: Side screen location.

    Hello John

    Thank you. I should have pulled up your old thread on side screens.

    I did get new TRF windows but could not see what held the front section in place. Albert said that it was sown in...
  20. Replies
    5
    Views
    209

    TR2/3/3A Re: Side screen location.

    Thank you.

    At the moment I am completely missing the covering material on the side screen window frame. That is what is making me concerned that I may be off. Coming up may help as I am very tight...
  21. Thread: New Member

    by DavidApp
    Replies
    1
    Views
    67

    Re: New Member

    Hello psutr3

    Welcome back to the forum.

    You will find things have not changed too much.

    I had my carbs rebuilt by Joe Curto in NY. He did a great job.

    The Pub is an area where almost...
  22. Replies
    8
    Views
    231

    TR2/3/3A Re: OD angle drive engaging the speedo cable

    I had the same questions a few weeks ago.
    My route for the cable.

    David
    62214

    62215
    62216
  23. Replies
    5
    Views
    209

    TR2/3/3A Side screen location.

    Getting ready to have my side screens recovered. Having seen a pair of side screens recovered by TRF. I realized what mine are missing. They have no covering on the window frame. Have I set the frame...
  24. Replies
    2
    Views
    163

    General TR Fuel filter before the pump.

    I added a fuel filter between the tank and the fuel pump. The tank was dry and clean when I installed it in the car. It had sat in a basement for 25 years+

    After a year and 1000 miles this is what...
  25. Replies
    8
    Views
    168

    Re: Looks ain't everything

    Hello Ian

    Welcome to the forum.

    Great looking E Type.
    Is it on the road or a project in waiting?
    You need to check out the Jaguar section of the forum where you will get plenty of tips and...
Results 1 to 25 of 2810
Page 1 of 113 1 2 3 4