• Recent Articles

  • Recent Forum Posts

    Bob_Spidell

    Re: Fuel gauge calibration procedure

    "Float forward" makes a good mnemonic.

    Bob_Spidell Today, 10:54 AM Go to last post
    Bob_Spidell

    Re: Brake hard line question

    I've seen similar on other, mostly older cars--IIRC, my dad's '65 Mustang had one--but it's usually only one or two coils. Maybe this vehicle had an issue

    Bob_Spidell Today, 10:52 AM Go to last post
    CJD

    Re: TR3A Drive shaft cork seal

    I'm going from memory, so someone correct me if I'm off, but I am pretty sure the drives shaft goes together like this:

    The male splines

    CJD Today, 10:49 AM Go to last post
    Snowkilts

    Re: TR3A Drive shaft cork seal

    Anybody have a picture or drawing anywhere showing where this goes? It's not shown on the drawing on the Moss website. I had my driveshaft apart last

    Snowkilts Today, 10:40 AM Go to last post
    CJD

    Re: Starter dog bolt

    Yeah, just to elaborate...I would consider 60ft-lbs to be the minimum I would use to hold everything tight. Then you can continue to turn until the starter

    CJD Today, 10:39 AM Go to last post
  • Recent Blog Posts

  • Twitter