• Recent Articles

  • Recent Forum Posts

    BobbyO

    Windshield Wiper mount rubber

    Need to replace the rubber on the windshield wiper motor mount. Is there any secret to doing this. Received replacement rubber from Moss. Should these

    BobbyO Today, 04:26 PM Go to last post
    dklawson

    Re: Ford Versus Ferrari Question

    IF they had wanted to make the calipers quickly removable it would have been possible with flush-face, no-drip couplers from companies like Staubli.

    dklawson Today, 03:59 PM Go to last post
    nevets

    Re: interesting article about converting classic cars to electric power

    There are well regarded Nasty Boys with American V8s instead of the original engines, so maybe electric motors have a place in the Austin Healey ecosystem?

    nevets Today, 03:36 PM Go to last post
    John Turney

    Re: Gasket, Inlet Manifold to Exhaust Manifold BJ8

    I think it provides some controlled heat transfer from the exhaust to intake to keep the fuel from condensing in the intake manifold.

    John Turney Today, 03:23 PM Go to last post
    AUSMHLY

    Re: Gasket, Inlet Manifold to Exhaust Manifold BJ8

    The engine gasket has fiber sandwiched between metal. I'll assume metal exterior for heat and the purpose of the gasket is to seal any air leakage.

    AUSMHLY Today, 03:00 PM Go to last post
  • Recent Blog Posts

    Two Fifty Tuna

    TR 250 Rear Sway Bar

    The Tr 250 has aluminum rear trailing arms. Has anyone successfully installed a rear sway bar? I am concerned the stress of the end reactions will damage the mounting points on arms.
    Anyone care to...

    Two Fifty Tuna 12-05-2019 01:45 AM
    ajsblack

    ajsblack

    [QUOTE=ajsblack;1125840]I am a new member and have not used forums before. I have two TR3 a' a right hand drive Stag a 1949 2000 roadster (that I am restoring) a 1947 1800 for parts. I have a lot...

    ajsblack 11-29-2019 05:14 PM
  • Twitter