• Recent Articles

  • Recent Forum Posts


    Re: Headlight Hi beam floor button fail?

    That is the only switch in the TR3 that I could not rebuild. I had to buy a new one when mine died.

    CJD Today, 09:43 PM Go to last post

    Re: Any trick to removing TR3 doors?

    Not a good idea. When you try fitting the parts you will see why. You have to loosened and tighten those bolts many, many,...did I remember to say...many

    CJD Today, 09:41 PM Go to last post

    Re: Engine removal questions

    It is generally easier to remove them together. If you remove the tranny first, you will have to support the rear of the engine, as the front mounts

    CJD Today, 09:37 PM Go to last post

    Re: caged nuts problems

    There is no better solution than replacing the cage nuts. If you try to use a non-caged option, you will need at least 2 helpers to remove and install

    CJD Today, 09:33 PM Go to last post

    Re: A question for the electrical crowd.

    The submain controls every room in the house including the kitchen. That's the first place I look when lights go out. The garage main panel also controls

    pdplot Today, 08:38 PM Go to last post
  • Recent Blog Posts


    Tr6 windscreen

    My windshield is milky looking around the edges.Is it delaminating?
    what type of glass should I replace it with? I notice a big disparity in prices of new windshields.
    I want safety glass right?...

    laneriddle Yesterday 11:45 AM

    Hi! From PADDINGTON, Sydney, Australia

    RobXK120 08-03-2020 07:07 PM

    Hi! From PADDINGTON, Sydney, Australia

    RobXK120 08-03-2020 07:04 PM

    I'm new.

    RobXK120 08-03-2020 07:02 PM

    Radiator drain

    Hello all,

    New member here...

    I'm working to get my 57 TR3 back on the road after sitting for 23 years. Last night I went to drain the radiator (in car) and remove the drain petcock which was...

    Snigolet 08-02-2020 10:39 AM
  • Twitter