• Motorcycles

    There is no available content in category Motorcycles
  • Recent Articles

  • Recent Forum Posts

    ckeithjordan

    Re: Fuel Shutoff Valve

    John,

    I'd love to have one and be willing to pay for the brass stock and your time!

    ckeithjordan Today, 05:38 PM Go to last post
    CJD

    Re: Fuel Shutoff Valve

    It was a breeze to cut. The most time was spent trying to decide how deep to groove the O-rings. I am sure that answer is in the machinist's handbook

    CJD Today, 05:32 PM Go to last post
    AUSMHLY

    Re: Gasket, Inlet Manifold to Exhaust Manifold BJ8

    New Gasket in photo is from Moss. Are there torque setting for both manifolds?

    AUSMHLY Today, 04:56 PM Go to last post
    Suncoaster

    Re: Bracing the tub for removal fom frame?

    Thanks, everybody! Great info.

    Since all the work will be done at the same shop, I think I'll probably go with John's method and ask the

    Suncoaster Today, 04:54 PM Go to last post
    sp53

    Re: Windshield Wiper mount rubber

    I used to muscle them in, but I noticed the installation gets more difficult, or the parts change. The last one I did, I used the original bolts and washers,

    sp53 Today, 04:52 PM Go to last post
  • Recent Blog Posts

    Two Fifty Tuna

    TR 250 Rear Sway Bar

    The Tr 250 has aluminum rear trailing arms. Has anyone successfully installed a rear sway bar? I am concerned the stress of the end reactions will damage the mounting points on arms.
    Anyone care to...

    Two Fifty Tuna 12-05-2019 01:45 AM
    ajsblack

    ajsblack

    [QUOTE=ajsblack;1125840]I am a new member and have not used forums before. I have two TR3 a' a right hand drive Stag a 1949 2000 roadster (that I am restoring) a 1947 1800 for parts. I have a lot...

    ajsblack 11-29-2019 05:14 PM
  • Twitter