• Motorcycles

    There is no available content in category Motorcycles
  • Recent Articles


    TR-3 NOS parts

    New Old Stock, in Stanpart boxes, overriders and bumperettes. $350.00 or BO

    Lucas License plate light/ NOS boxed. $75.00 or BO... read more
    RLN 03-27-2020, 12:01 AM
  • Recent Forum Posts


    Re: Inner sill opinion

    Tim, if you have a TIG set you are golden. I only used MIG because I had not budgeted for the TIG until just this year. The beauty of the TIG is you

    CJD Today, 10:18 AM Go to last post
    Healey Nut

    Re: BJ8 Frame Rust Options?

    When you picked the car up did you happen to check the door gaps and if they changed or if the doors actually opened on their own or they were different

    Healey Nut Today, 10:17 AM Go to last post

    TR 4A cylinder head on TR 3 engine

    Good Morning
    I have a 1957 TR 3 engine (TS 16173E) and I am planning to put a TR 4A cylinder on it.
    From reading so far, this cylinder head

    jfcdo Today, 10:14 AM Go to last post

    Re: Newbie with a 58 Bugeye

    welcome - sounds like a lovely project and a pretty clean slate!

    Pop over to the Spridgets forum where we would love to see pics!

    JPSmit Today, 10:14 AM Go to last post

    Re: BJ8 Frame Rust Options?

    That was exactly my thought as well, but when I had it in the air (picked up with my fork lift to above head height), I had a chance to walk the entire

    Peepers Today, 10:10 AM Go to last post
  • Recent Blog Posts


    TR-3 NOS parts

    RLN 03-27-2020 12:05 AM

    TR6 gauge bezels

    Just finished refurbishing my 74 gauges and the bezel (52mm) to one of the smaller gauges (fuel, but they are all the same) has a broken tab.
    Iím looking for a replacement bezel (chrome with black...

    EWD 03-26-2020 10:31 AM
  • Twitter