• Recent Articles


    General Public's Opinion of our LBC's

    Of Prejudice, Perceptions and LBC's...
    by Dr Entropy

    It has always confounded me: the manner in which a major portion of the US public perceive
    our cars. For the most part it has been my experience that they think of the cars as “toys” or “cute” and
    “flimsy”. “Unreliable” comes in there too.

    A personal case in point:
    In another life I worked as a photographer for a studio in western Pennsylvania. The... read more
    DrEntropy Yesterday, 01:29 PM


    Lotus  Non-British Cars  Anecdotal 

    Lucas DR-3 wiring de-mystified

    Two Position Rolls Royce Wiper Switch Pin-out
    By DrEntropy

    This article is written to help identify the connections originating at the two-speed windscreen wiper switch where the colour-coded fabric of the wiring loom has faded beyond all possible identification.

    The motor is a DR-3, two-speed unit. The switch is... read more
    DrEntropy 05-30-2020, 01:20 PM
  • Recent Forum Posts

    Chas B.

    Re: Not So "New" Member.

    I started on Basil's "British Car Forum" pert near when Basil started the British Car Forum..
    There was a LOT of stuff going on, several

    Chas B. Today, 02:40 AM Go to last post

    Re: Steering Peg in Steering Gearbox

    Simon, can you explain in a bit more detail exactly why the steering went. Was it because the peg snapped or did the whole system seize up in some way?

    DerekJ Today, 02:29 AM Go to last post

    Re: Baby Tenax Fasteners

    I thought you had the females from the tops...but were short the rear studs?

    CJD Today, 12:36 AM Go to last post

    Re: Side screen location.

    The farther into the slot the front flap goes, the better the seal, but they should not go past fully in or you will get a bind. On the top, the flap

    CJD Today, 12:28 AM Go to last post

    Re: Rear wheel cylinders for 54 TR-2

    12 is how you bleed the cylinder, so you will need 2 of those. The adjusters are also separate from the cylinders. On the TR2 they are not wheels, but

    CJD Today, 12:23 AM Go to last post
  • Recent Blog Posts

    Mike Weikert

    1956 TR3 carburetor problem

    The number 2 piston on my SU carburetor will not move up and down when engine is being accelerated. When the engine is not running the number 2 piston will not move all the way to the bottom when it...

    Mike Weikert 05-31-2020 11:13 PM

    Chassis Suppliers

    BritCars4KGM 05-16-2020 10:44 AM
  • Twitter