• Non-British Cars

    There is no available content in category Non-British Cars
  • Recent Articles

  • Recent Forum Posts

    F Schreiber

    Re: Speedi-sleeve p/n needed

    I dont' know the p/n but if you get on the S/K site that have a list for some cars, and if it doesn't have any Healey, then its easy to measure the shaft

    F Schreiber Today, 10:35 PM Go to last post
    F Schreiber

    Re: Transmission / OD dilemma

    Thanks for the feed back. Thats good support for keeping and rebuilding what I have. And keeping the carbs I have. My rear end is the 3.909. So from

    F Schreiber Today, 10:22 PM Go to last post
    steveg

    Re: Speedi-sleeve p/n needed

    Michael,
    Are you putting hylomar or other sealant on the paper gasket?

    steveg Today, 09:44 PM Go to last post
    Michael Oritt

    Re: Speedi-sleeve p/n needed

    I pulled the left axle shaft today and found to my amazement that there was no paper gasket between the inner face of the axle flange and the hub. I

    Michael Oritt Today, 09:03 PM Go to last post
    ichthos

    Re: TR6 wonít start, no lights

    Thanks. I ordered the book. I have a 69. Thanks for the detailed instructions! I just got a tester and some leads. I am not home at the moment, but I

    ichthos Today, 08:55 PM Go to last post
  • Recent Blog Posts

    garystrumphet

    Garystrumpet

    My car has had its rear lever action shocks replaced with a Wheewlright tube shock conversion. The shocks are stamped made in england 010672. What shocks replace the ones I have? Where to find them?

    garystrumphet 06-09-2019 04:40 PM
  • Twitter