• Recent Articles

  • Recent Forum Posts


    Re: Rear Transmission Seal 74 TR6

    The drive shaft may be stiff, but should move for you. Also remember to tape the U-joint so the caps will not fall off and spill needle bearings everywhere.

    CJD Today, 10:20 AM Go to last post

    Re: Which choke cable

    The twist lock cable is the original style. It is a bit easier to pull if you twist first, as then it misses the detents, which add a bit to the pull

    CJD Today, 10:14 AM Go to last post

    Which choke cable

    My choke is a PITA. I need to pull it with all the strength my aging hand and fingers can muster and still if I have a helper push the lever from inside

    TomMull Today, 10:00 AM Go to last post

    Re: Gaskets and seals

    The best method is what Paul suggests; pull engine and gearbox as a unit. Replace all seals, along with pan gaskets and the ones at the left side of the

    DrEntropy Today, 09:59 AM Go to last post

    Re: sealing master cylinder pocket

    3M makes a seem bedding sealer that is tan or black and never completely hardens, yet can be removed easier than the old "black tar" seems sealer.

    CJD Today, 09:41 AM Go to last post
  • Recent Blog Posts



    One of my Reno British Car Club members ask what is the correct paint color for his MGC Valve cover Black Green Red I have seen crackle Black. Madflyer

    Madflyer 09-17-2020 11:19 PM

    indicator lights Austin Healey BT7

    I have an issue with my indicators. All is good until I turn on side/headlights. Indicators stop working but dash signal light still operates.
    Any ideas?
    Wiring is good - I think.

    BillRichards 09-17-2020 03:06 AM

    V-belt obstruction

    2liter4cyl 09-10-2020 12:07 PM
  • Twitter