• Rover/Land Rover

    There is no available content in category Rover/Land Rover
  • Recent Articles

  • Recent Forum Posts


    Re: Steering rack clearance

    I just checked mine. They are 7/16. I suspect you have the wrong tie-rod ends and the taper is not fitting into the steering arm, so you don't have much

    Sarastro Today, 07:49 PM Go to last post

    Re: Electrical Issues Need Help

    Thank you for the feedback. All was working fine, then gen light came on and car died. Tried to restart and nothing🤷🏼*♂️

    NYC5513 Today, 07:45 PM Go to last post

    Hello all!

    Hey, mike in North Dakota. long time owner of 100-6, due for resto.... and now own a 3000 also. Hope to meet you all sometime soon at a conclave.

    signguy68 Today, 07:32 PM Go to last post

    Re: Weber balancer on HD8s

    Hi Steve,

    So, what does it do that wouldn't be covered by the Slow Run Adjustment, Fast Idle Adjustment, or Throttle Shavt Stop lever along

    RAC68 Today, 07:27 PM Go to last post

    Re: Electrical Issues Need Help

    First of all, you will probably get more specific help on the Spridgets forum.

    However, I'll take a stab. I think sprites are wired the

    red57 Today, 06:58 PM Go to last post
  • Recent Blog Posts

    Two Fifty Tuna

    TR 250 Rear Sway Bar

    The Tr 250 has aluminum rear trailing arms. Has anyone successfully installed a rear sway bar? I am concerned the stress of the end reactions will damage the mounting points on arms.
    Anyone care to...

    Two Fifty Tuna 12-05-2019 01:45 AM


    [QUOTE=ajsblack;1125840]I am a new member and have not used forums before. I have two TR3 a' a right hand drive Stag a 1949 2000 roadster (that I am restoring) a 1947 1800 for parts. I have a lot...

    ajsblack 11-29-2019 05:14 PM
  • Twitter