• Recent Articles

  • Recent Forum Posts


    Re: Hub out of round?

    If that hub has.012" runout it is time to throw it out.
    The vibration will be noticeable and you will provably ruin that bearing you just installed

    Merlin63Tr4 Today, 11:23 AM Go to last post

    Re: Steering Column Loose

    For future reference removing the tamper-proof ignition lock bolts....

    Mount a 3" diameter, 1/16" thick cut off wheel in a die

    dklawson Today, 11:04 AM Go to last post

    Re: WWII Fighter Pilots Goggles

    My thoughts exactly Doc! Methylene Chloride isn't user friendly, even though I appreciate the information. If it comes down to that, I do have a mask

    PAUL161 Today, 10:22 AM Go to last post

    Hub out of round?

    We just replaced the bearings in the rear outer axles. The guy that pressed the hubs off bent one, and the other was close. I had an extra hub for the

    Jerry Today, 10:06 AM Go to last post

    Re: Carb float

    Bob - To be fair, nobody said deterioration of brass was a problem due to modern fuels. I'd guess Holley etc were using plastic floats which at some point

    steveg Today, 10:00 AM Go to last post
  • Recent Blog Posts



    My car has had its rear lever action shocks replaced with a Wheewlright tube shock conversion. The shocks are stamped made in england 010672. What shocks replace the ones I have? Where to find them?

    garystrumphet 06-09-2019 04:40 PM
  • Twitter