• Recent Articles

  • Recent Forum Posts

    Lightning

    Re: Do you recognize this wheel?

    Thanks for the information guys! This has been very helpful. I searched for Tech Dell Minilite and hit pay dirt. I found a website that has original

    Lightning Today, 03:52 AM Go to last post
    twas_brillig

    Re: AH EFI build... again

    We're converting a 1972 BMW 2002 (hopefully) to EFI using gutted Weber DCOEs as throttle bodies with injector bungs from Simple Digital Systems welded

    twas_brillig Today, 02:04 AM Go to last post
    glemon

    Re: Bugsy IV - Painting, Cutting, Buffing is done

    Haven't tried rollers, but have done DIY garage painting and polishing, lots of sweat equity and a big mess, but agree the money saved and knowing you

    glemon Today, 01:59 AM Go to last post
    Rob Glasgow

    Re: BJ8 brake master cylinder question

    Digger, I'm not sure if you are measuring the diameter of the rubber cover between 1 and 2 (also 3and 4) or the actual metal with the rubber removed.

    Rob Glasgow Today, 01:44 AM Go to last post
    DavidApp

    Here is one for you Electronic experts.

    I have a Thankless water heater that is malfunctioning.It is a Rheem EcoSense RTE13. Some times it heats and sometimes it does not. You have to turn

    DavidApp Today, 01:34 AM Go to last post
  • Recent Blog Posts

    Two Fifty Tuna

    TR 250 Rear Sway Bar

    The Tr 250 has aluminum rear trailing arms. Has anyone successfully installed a rear sway bar? I am concerned the stress of the end reactions will damage the mounting points on arms.
    Anyone care to...

    Two Fifty Tuna 12-05-2019 01:45 AM
    ajsblack

    ajsblack

    [QUOTE=ajsblack;1125840]I am a new member and have not used forums before. I have two TR3 a' a right hand drive Stag a 1949 2000 roadster (that I am restoring) a 1947 1800 for parts. I have a lot...

    ajsblack 11-29-2019 05:14 PM
  • Twitter