• Recent Articles

  • Recent Forum Posts

    waltesefalcon

    BigBoy

    Ihave been busy at work and haven't been paying as much attention to the UP's BigBoy project as I had been. A couple of weeks ago this happened:

    waltesefalcon Today, 01:20 PM Go to last post
    charleyf

    Re: Where to buy a new crown wheel & pinion for TR4A

    You actually have a choice of ratios as well as suppliers. Of course there is the 4.1 and 3.7 ratios as well as the 3.45 ratio that was used in the TR250.

    charleyf Today, 01:11 PM Go to last post
    NilsGTR4A

    Re: On to the summit!

    Well this is a surprise. A British sports car forum where we're talking about mountaineering. Does Sir Edmund drive a Triumph?

    Its a shame

    NilsGTR4A Today, 01:09 PM Go to last post
    KVH

    Re: vent lid rubber

    On my 4A I just waited awhile and the fit improved. I think the weather and engine heat helped.

    KVH Today, 01:00 PM Go to last post
    CraigC

    Re: New cylinder heads

    Derek, 150 is the torque not the HP. HP numbers are on the left side of the graph and in this case it is 111 HP.

    The use of dual graph graduations

    CraigC Today, 12:56 PM Go to last post
  • Recent Blog Posts

    pappap50

    MGB wire wheel problems

    I am having problems keeping the wire wheels on my MGB tight. They loosen up and make a noise that sounds like a bad universal joint. I can tighten them to make the noise go away, but they become...

    pappap50 05-14-2019 10:54 PM
  • Twitter