• Recent Articles

  • Recent Forum Posts


    Re: Weber balancer on HD8s

    I'd say there's very little difference between the butterfly shafts at 2000 rpm, such that the difference between the butterflies at idle is

    steveg Today, 10:04 PM Go to last post

    TR3B Tire/Wheel Advice

    Hey out there.
    Looking for tire/wheel advice for a '62 TR3B.

    Just acquired a new set of centre-lock Minator Minilite replicas

    Kestrel Today, 09:57 PM Go to last post

    Re: TR3B New Orleans

    Thanks Mickey.
    Raiders Class of '69.
    Who Dat?

    Kestrel Today, 09:39 PM Go to last post

    Re: Temperature sensor Help me

    I don't believe my father would use a torch to seal a tube full of ether--he wasn't stupid--nor did I say as much (there are other ways to solder). He

    Bob_Spidell Today, 09:36 PM Go to last post

    Re: Bicycle "Art"

    old school

    sail Today, 08:47 PM Go to last post
  • Recent Blog Posts

    Two Fifty Tuna

    TR 250 Rear Sway Bar

    The Tr 250 has aluminum rear trailing arms. Has anyone successfully installed a rear sway bar? I am concerned the stress of the end reactions will damage the mounting points on arms.
    Anyone care to...

    Two Fifty Tuna 12-05-2019 01:45 AM


    [QUOTE=ajsblack;1125840]I am a new member and have not used forums before. I have two TR3 a' a right hand drive Stag a 1949 2000 roadster (that I am restoring) a 1947 1800 for parts. I have a lot...

    ajsblack 11-29-2019 05:14 PM
  • Twitter