• Recent Articles

  • Recent Forum Posts

    robolab

    Re: Gearbox and Overdrive Oil Level

    The discussion about the filling quantity makes me wonder. So today I drained the oil from the gearbox and overdrive by removing the drain plugs on the

    robolab Today, 03:11 PM Go to last post
    Crusty

    Re: side change gear box stuck in top gear

    Hello Bob,
    The gear lever is stuck fast. I have used a fair bit of force but I have been afraid if I use too much I might make the problem worse.

    Crusty Today, 02:51 PM Go to last post
    Boink

    Nice blurb on FUEL WASH...

    I have always warmed up an SU-carb-based car (and, frankly, had to so-as to get the car running nice), but with fuel injection:

    http://bestride.com/research/tips-and-tricks/is-it-safe-to-warm-up-your-cars-engine-when-its-cold

    Boink Today, 02:37 PM Go to last post
    nichola

    Re: Why were all these shims in there?

    Thank you, I will definitely check the alignment again after a few miles on the road. I wish I still owned my TR3, loved that car but let it go. (along

    nichola Today, 02:36 PM Go to last post
    DrEntropy

    Re: GM killing off the Holden

    Saw a number of them in Thailand, back-when. They struck me as obviously "western" compared with most of the other vehicles there. Surprised

    DrEntropy Today, 02:21 PM Go to last post

  • Recent Blog Posts

    ggraham8

    Armstrong "RX" Shocks

    Does anyone know what the "RX" is for that is embossed on my shocks? see picture

    ggraham8 02-11-2020 02:13 PM
    Lockheed-driver

    TR2 manifold question

    Hi All. I’ve been restoring a TR2 for some time now. Learning as I go. I have both manifolds restored and ready to install. I started to look at the box full of bits that the previous owner had used...

    Lockheed-driver 02-03-2020 10:18 AM

  • Twitter