• Recent Articles

  • Recent Forum Posts

    John Turney

    Re: Leak into boot

    Water may be coming in around the bottom of the tank if the seal under the tank isn't complete. Do you have water on the floor to the rear of the tank?

    John Turney Today, 05:19 PM Go to last post
    Joe Schlosser

    Re: No Marks on Timing Gear

    Some cam timing is given at max lift for #1 cylinder intake valve. Not too difficult to do with a good TDC wheel and dial indicator. As absolute max lift

    Joe Schlosser Today, 05:05 PM Go to last post
    Joe Schlosser

    Re: Bug Eye fuel gage sending unit

    Confusion
    I put the old sending unit on the bench and did a continuity check with multimeter set to 200 Ohm. Approximately 30 ohm empty and about

    Joe Schlosser Today, 04:55 PM Go to last post
    Healey Nut

    Re: Harmonic Balancer

    So after looking at Steve Gs pic in post 8 I took what I had to my sandblasting cabinet to see what I could uncover .
    Heres the results . My question

    Healey Nut Today, 04:23 PM Go to last post
    TomMull

    Re: Newly purchased poor quality timing gear

    The policy with most suppliers I've dealt with is to issue a refund and then you have to purchase another. Glad you found a good used one though.

    TomMull Today, 04:21 PM Go to last post
  • Recent Blog Posts

    pappap50

    MGB wire wheel problems

    I am having problems keeping the wire wheels on my MGB tight. They loosen up and make a noise that sounds like a bad universal joint. I can tighten them to make the noise go away, but they become...

    pappap50 05-14-2019 10:54 PM
  • Twitter