• JPSmit

    There is no available content written by JPSmit
  • Recent Articles

  • Recent Forum Posts

    steveg

    Re: Weber balancer on HD8s

    Ray,
    I'd say there's very little difference between the butterfly shafts at 2000 rpm, such that the difference between the butterflies at idle is

    steveg Today, 10:04 PM Go to last post
    Kestrel

    TR3B Tire/Wheel Advice

    Hey out there.
    Looking for tire/wheel advice for a '62 TR3B.


    Just acquired a new set of centre-lock Minator Minilite replicas

    Kestrel Today, 09:57 PM Go to last post
    Kestrel

    Re: TR3B New Orleans

    Thanks Mickey.
    Raiders Class of '69.
    Who Dat?

    Kestrel Today, 09:39 PM Go to last post
    Bob_Spidell

    Re: Temperature sensor Help me

    I don't believe my father would use a torch to seal a tube full of ether--he wasn't stupid--nor did I say as much (there are other ways to solder). He

    Bob_Spidell Today, 09:36 PM Go to last post
    sail

    Re: Bicycle "Art"

    old school

    sail Today, 08:47 PM Go to last post
  • Recent Blog Posts

    Two Fifty Tuna

    TR 250 Rear Sway Bar

    The Tr 250 has aluminum rear trailing arms. Has anyone successfully installed a rear sway bar? I am concerned the stress of the end reactions will damage the mounting points on arms.
    Anyone care to...

    Two Fifty Tuna 12-05-2019 01:45 AM
    ajsblack

    ajsblack

    [QUOTE=ajsblack;1125840]I am a new member and have not used forums before. I have two TR3 a' a right hand drive Stag a 1949 2000 roadster (that I am restoring) a 1947 1800 for parts. I have a lot...

    ajsblack 11-29-2019 05:14 PM
  • Twitter