• Bob McElwee

    There is no available content written by Bob McElwee
  • Recent Articles

  • Recent Forum Posts

    Drone Dog

    Re: PCV and oil leaks

    Steve
    when i tested my set up, i tried it with the engine idling and at higher revs.... 2000 rpm, 3000 rpm, etc. i also watch the vac gauge during

    Drone Dog Today, 07:41 PM Go to last post
    Basil

    Re: New Member Mike K - 1976 Tr6 owner Starting restoration

    Hi Mike! Glad to have you aboard! If you have any questions specific to your TR6, we have a very active Triumph forum here, so be sure to post your

    Basil Today, 07:34 PM Go to last post
    Jerry

    Re: PCV and oil leaks

    I installed one of these on two cars. In both cases, less leaks and no burning oil, no more smoke. I have one on my 1380 mini and a 2.2 liter TR3.

    Jerry Today, 07:19 PM Go to last post
    Jerry

    Re: Starter failure

    The spring should be steel, I removed the starter and fished in the hole with a magnet. Got all the loose parts and put it back together. But I was

    Jerry Today, 07:15 PM Go to last post
    Dr_Mike

    Re: More small nuts ( and studs!)

    thanks, john.

    I just found the nut size at the back of parts list: the studs are 10UNF so that is not a problem. I was afraid the studs

    Dr_Mike Today, 06:51 PM Go to last post
  • Recent Blog Posts

    gfreeman

    stromberg zenith carb dash pot

    Hello to all. The dash pot oil on one of my carbs on my TR 6 keeps disappearing. Any clues on why and where it goes? What is the fix?

    gfreeman 08-07-2019 10:13 AM
  • Twitter