• NutmegCT

    There is no available content written by NutmegCT
  • Recent Articles

  • Recent Forum Posts

    Joe Schlosser

    Re: No Marks on Timing Gear

    Some cam timing is given at max lift for #1 cylinder intake valve. Not too difficult to do with a good TDC wheel and dial indicator. As absolute max lift

    Joe Schlosser Today, 05:05 PM Go to last post
    Joe Schlosser

    Re: Bug Eye fuel gage sending unit

    Confusion
    I put the old sending unit on the bench and did a continuity check with multimeter set to 200 Ohm. Approximately 30 ohm empty and about

    Joe Schlosser Today, 04:55 PM Go to last post
    Healey Nut

    Re: Harmonic Balancer

    So after looking at Steve Gs pic in post 8 I took what I had to my sandblasting cabinet to see what I could uncover .
    Heres the results . My question

    Healey Nut Today, 04:23 PM Go to last post
    TomMull

    Re: Newly purchased poor quality timing gear

    The policy with most suppliers I've dealt with is to issue a refund and then you have to purchase another. Glad you found a good used one though.

    TomMull Today, 04:21 PM Go to last post
    Jim_Gruber

    Re: Leaking 5-speed drain plug

    Interesting fix Trevor. Driveshaft gets dropped off tomorrow for check on rear seal. Hope this fixes my noise. Drew on the other hand this may be a fix

    Jim_Gruber Today, 03:23 PM Go to last post
  • Recent Blog Posts

    pappap50

    MGB wire wheel problems

    I am having problems keeping the wire wheels on my MGB tight. They loosen up and make a noise that sounds like a bad universal joint. I can tighten them to make the noise go away, but they become...

    pappap50 05-14-2019 10:54 PM
  • Twitter