• metropolisman

    There is no available content written by metropolisman
  • Recent Articles

  • Recent Forum Posts

    bobhustead

    Re: bleeding brakes

    Did you bench bleed the new master? If not, you can do so in place by bleeding at the first fitting after the cylinder. This raises dangers to the paint

    bobhustead Today, 02:11 PM Go to last post
    TuffTR250

    Re: bleeding brakes

    What brake fluid are you using? Silicone Dot 5 is quite difficult to bleed. It can hold tiny bubbles. Have to be very careful filling the reservoir to

    TuffTR250 Today, 01:54 PM Go to last post
    maynard

    They all look alike

    maynard Today, 01:17 PM Go to last post
    mikephillips

    Re: 60 vs 72 Spoke Wire Wheels

    One thing no one has mentioned is that before buyinganything you need to check the condition of the hubs to be sure the splines arenot worn out. When

    mikephillips Today, 01:11 PM Go to last post
    cityslicks

    bleeding brakes

    Is there a secret to bleeding the brakes on TR 3. All new components and still can't get them to bleed. Started at the riders rear brake as normal but

    cityslicks Today, 01:09 PM Go to last post
  • Recent Blog Posts

  • Twitter