• Recent Articles

  • Recent Forum Posts

    drooartz

    Re: Leaking 5-speed drain plug

    Thanks for the tips. My plan now is to swap my spare trans in and see what can be done with my broken one. Worse case is it becomes a donor for internals.

    drooartz Today, 05:32 PM Go to last post
    John Turney

    Re: Oil catch tank

    Hi Lin,

    That was one of my PCV experiments. Most PCV valve installations, including my early one, don't have a filtered air inlet.

    John Turney Today, 05:29 PM Go to last post
    John Turney

    Re: Leak into boot

    Water may be coming in around the bottom of the tank if the seal under the tank isn't complete. Do you have water on the floor to the rear of the tank?

    John Turney Today, 05:19 PM Go to last post
    Joe Schlosser

    Re: No Marks on Timing Gear

    Some cam timing is given at max lift for #1 cylinder intake valve. Not too difficult to do with a good TDC wheel and dial indicator. As absolute max lift

    Joe Schlosser Today, 05:05 PM Go to last post
    Joe Schlosser

    Re: Bug Eye fuel gage sending unit

    Confusion
    I put the old sending unit on the bench and did a continuity check with multimeter set to 200 Ohm. Approximately 30 ohm empty and about

    Joe Schlosser Today, 04:55 PM Go to last post
  • Recent Blog Posts

    pappap50

    MGB wire wheel problems

    I am having problems keeping the wire wheels on my MGB tight. They loosen up and make a noise that sounds like a bad universal joint. I can tighten them to make the noise go away, but they become...

    pappap50 05-14-2019 10:54 PM
  • Twitter