• Recent Articles

  • Recent Forum Posts


    Re: Here is one for you Electronic experts.

    OK so where is the magnet which is supposed to trigger the reed switch? Inside the pipe hiding behind the circuit board. That switch is probably oriented

    70herald Today, 04:06 AM Go to last post

    Re: AH EFI build... again

    I've got that book - won't claim I understand all or even some of it! Simple Digital Systems started out years ago with a retro-fit automotive EFI system,

    twas_brillig Today, 02:40 AM Go to last post

    Re: Here is one for you Electronic experts.

    Hello Randall

    Thank you.
    I had looked for that switch a while ago with no luck. Bookmarked the page now.

    I have just tested

    DavidApp Today, 12:43 AM Go to last post

    Re: AH EFI build... again

    Twas_brilling, FWIW .... I've read a lot of articles on fuel injection and one of the best sources for me has been "Performance Fuel Injection Systems"

    HealeyPassion Today, 12:20 AM Go to last post

    Re: problem just rebuilt SU carbs

    For some reason I found that reducing the OD of the bushing to make it a light press fit had more effect on the problem than increasing the ID. Also,

    titanic Yesterday, 11:49 PM Go to last post
  • Recent Blog Posts

    Two Fifty Tuna

    TR 250 Rear Sway Bar

    The Tr 250 has aluminum rear trailing arms. Has anyone successfully installed a rear sway bar? I am concerned the stress of the end reactions will damage the mounting points on arms.
    Anyone care to...

    Two Fifty Tuna 12-05-2019 01:45 AM


    [QUOTE=ajsblack;1125840]I am a new member and have not used forums before. I have two TR3 a' a right hand drive Stag a 1949 2000 roadster (that I am restoring) a 1947 1800 for parts. I have a lot...

    ajsblack 11-29-2019 05:14 PM
  • Twitter