• Recent Articles

  • Recent Forum Posts

    Frank Canale

    Re: Early TR4 seat pans

    Great job, David. A little planishing and that will be a great panel. When I started out my boot floor the first one looked a lot like that but mine is

    Frank Canale Yesterday, 11:50 PM Go to last post
    Rich8285

    Re: Rust in Block? Help needed!

    Hi Greg,

    Yes. The two green arrows show similar areas on the block with no holes in them. The yellow arrow shows the area with the rust

    Rich8285 Yesterday, 11:23 PM Go to last post
    DavidApp

    Home made.

    Having some time to spare I decided to make another small table. This one is made with some Red Oak I milled a couple of years ago.
    I say another

    DavidApp Yesterday, 11:09 PM Go to last post
    grimes6

    Re: Rust in Block? Help needed!


    Is the rust hole the one with the yellow arrow ? If it is it is it corresponds to the hole between cylinders 4 and 5 in the image attached

    grimes6 Yesterday, 11:02 PM Go to last post
    DavidApp

    Re: Recommended Tire Life

    I watch a guy on You Tube who restores and repairs old Greyhound buses.
    I have heard him remind drivers on test drives that the bus is rolling

    DavidApp Yesterday, 10:53 PM Go to last post
  • Recent Blog Posts

    Madflyer

    Madflyer

    I am looking into getting two Triumph GT 6's one is a SCCA rated car and the other is a motor less parts car. Any thoughts. Madflyer

    Madflyer 10-25-2020 03:58 PM
  • Twitter