• 2long

    There is no available content written by 2long
  • Recent Articles

  • Recent Forum Posts

    dklawson

    Re: Temperature sensor Help me

    You can make a DIY repair of mechanical temperature gauges IF the dead gauge (when cold at rest) has its needle against the lower stop pin. Follow the

    dklawson Today, 07:49 PM Go to last post
    TomMull

    Re: When do you replace things?

    I do change the points on my old cars every Spring and usually look at the plugs at the same time. I almost always put them back in unless there's been

    TomMull Today, 07:13 PM Go to last post
    Bob_Spidell

    Re: Temperature sensor Help me

    A little bit of teflon tape or pipe sealant won't hurt.

    Most of you have probably heard this story, but my dad--as usual--thought he could

    Bob_Spidell Today, 07:02 PM Go to last post
    Suncoaster

    Re: Frame off vs. body on restoration

    Thanks, David! That is good info.

    Suncoaster Today, 05:25 PM Go to last post
    Boink

    Bicycle "Art"

    A new an novel activity in the modern world...

    https://www.standard.co.uk/news/london/cyclist-spends-nine-hours-pedalling-image-of-reindeer-through-london-a4308941.html

    Boink Today, 05:22 PM Go to last post
  • Recent Blog Posts

    Two Fifty Tuna

    TR 250 Rear Sway Bar

    The Tr 250 has aluminum rear trailing arms. Has anyone successfully installed a rear sway bar? I am concerned the stress of the end reactions will damage the mounting points on arms.
    Anyone care to...

    Two Fifty Tuna 12-05-2019 01:45 AM
    ajsblack

    ajsblack

    [QUOTE=ajsblack;1125840]I am a new member and have not used forums before. I have two TR3 a' a right hand drive Stag a 1949 2000 roadster (that I am restoring) a 1947 1800 for parts. I have a lot...

    ajsblack 11-29-2019 05:14 PM
  • Twitter