• Recent Articles

  • Recent Forum Posts

    Digger

    Re: BJ8 brake master cylinder question

    Rob,

    That works for the old one I took out, but not for the new one. I am going to follow the advice to return the new one and have the

    Digger Today, 12:06 PM Go to last post
    Jerry

    Re: Here is one for you Electronic experts.

    I have 3 units in my house. They have a computer board on all three and it is very picky about everything running right. One of sensors picks up particles

    Jerry Today, 11:29 AM Go to last post
    Jerry

    Re: Scroll Air Compressor

    I have never seen a scroll this small. Large commercial units are more efficient , and quiet. I sold a 25hp unit a few years ago. I would put out enough

    Jerry Today, 11:26 AM Go to last post
    HealeyPassion

    Re: AH EFI build... again

    That's quite a project Jedi Knight. Couple concerns... based on my experience, you might find you have way more air than you need with those big Webers…

    HealeyPassion Today, 11:05 AM Go to last post
    HealeyPassion

    Re: AH EFI build... again

    Thank you for those Alwyn! Good to see her out and about 'down under'! I did love that car... I don't sell them because I don't like them anymore...

    HealeyPassion Today, 10:53 AM Go to last post

  • Recent Blog Posts

    Two Fifty Tuna

    TR 250 Rear Sway Bar

    The Tr 250 has aluminum rear trailing arms. Has anyone successfully installed a rear sway bar? I am concerned the stress of the end reactions will damage the mounting points on arms.
    Anyone care to...

    Two Fifty Tuna 12-05-2019 01:45 AM
    ajsblack

    ajsblack

    [QUOTE=ajsblack;1125840]I am a new member and have not used forums before. I have two TR3 a' a right hand drive Stag a 1949 2000 roadster (that I am restoring) a 1947 1800 for parts. I have a lot...

    ajsblack 11-29-2019 05:14 PM

  • Twitter