• Recent Articles

  • Recent Forum Posts

    Lin

    Re: Oil catch tank

    John,
    So, what did you do for pressure relief and venting of the rocker cover?
    Lin

    Lin Today, 09:31 PM Go to last post
    trrdster2000

    Re: Zero acceleration power / Carís RPMs surge when you get in it.

    Thanks for the update and you are heading in the right direction.
    New thermostat should help, most run the 186 degrees or close to it. Good chance

    trrdster2000 Today, 09:17 PM Go to last post
    peterriley

    Re: New Build Stock Wheels?

    I know exactly what you're saying Sax man- I've tried everything to get my steel road wheels to run straight and true for my TR 3A with incremental improvements

    peterriley Today, 08:49 PM Go to last post
    John Turney

    Re: Oil catch tank

    If the can is connected to the T at the top of the valve cover, one won't get syphoning. If the can is connected to the vertical pipe from the side cover

    John Turney Today, 08:42 PM Go to last post
    charleyf

    Re: Where to buy a new crown wheel & pinion for TR4A

    I do not have direct experience with the German units . I understood that the bolts holding the ring gear onto the carrier were drilled smaller than

    charleyf Today, 08:29 PM Go to last post
  • Recent Blog Posts

    pappap50

    MGB wire wheel problems

    I am having problems keeping the wire wheels on my MGB tight. They loosen up and make a noise that sounds like a bad universal joint. I can tighten them to make the noise go away, but they become...

    pappap50 05-14-2019 10:54 PM
  • Twitter