• Recent Articles

  • Recent Forum Posts

    DavidApp

    Re: Hints on sealing the sump gasket.

    Hello Steve.

    Thank you.

    It looks like the 2 bolts on the drivers side. The one below the timing chain cover and the first timing

    DavidApp Today, 10:16 PM Go to last post
    Basil

    Re: Six turning and four burning

    At around 4:11 in that fil clip, see if you can spot a boo boo.

    Basil Today, 10:09 PM Go to last post
    sp53

    Re: Hints on sealing the sump gasket.

    Yes some of those bolts bottom out and some go through into the motor. The ones on the front plate that go into the aluminum bridge block bottom out.

    sp53 Today, 10:00 PM Go to last post
    DavidApp

    Re: Hints on sealing the sump gasket.

    I did set the regulator to 70 using an air setup. Had to regrind the seat to get it to seal and added a bit to the spring so the adjusting screw was not

    DavidApp Today, 09:33 PM Go to last post
    sp53

    Re: Hints on sealing the sump gasket.

    Hey David If the leak is in the front and not the side, my experience is that the cork gaskets on the bridging piece are leaking back through or between

    sp53 Today, 09:31 PM Go to last post
  • Recent Blog Posts

    gfreeman

    stromberg zenith carb dash pot

    Hello to all. The dash pot oil on one of my carbs on my TR 6 keeps disappearing. Any clues on why and where it goes? What is the fix?

    gfreeman 08-07-2019 10:13 AM
  • Twitter