• Lucas DR-3 wiring de-mystified

    Two Position Rolls Royce Wiper Switch Pin-out
    By DrEntropy


    This article is written to help identify the connections originating at the two-speed windscreen wiper switch where the colour-coded fabric of the wiring loom has faded beyond all possible identification.


    The motor is a DR-3, two-speed unit. The switch is a seven terminal,three position (off, low speed, high speed) piece:


    Attachment 63954


    Attachment 63955







    At the side of the switch are numbers stamped into the metal case,identifying each terminal, not in sequential order.


    Using a VOM ( Volt Ohm Meter), isolate each wire one-at-a-time and find the corresponding wire at the engine compartment, marking it for later identification with the appropriate switch terminal. Once all are ID’d and reconnected, reinstall the switch and associated facia and knobs.
    Assuming the motor has been rebuilt and has accompanying six-wire identification, using the conventional British wiring identification colour codes, the connections are as follows (main colour/tracer colour):


    Switch terminals:
    #1 to the brown or brown/blue motor wire
    #2 to the white or white/green “ “
    #3 to the yellow or yellow/green “ “
    #4 to the red or red/green “ “
    #5 to the blue or blue/green “ “
    #6 is internally wired into the ignition +12V supply with ignition on.
    #7 goes through the micro-switch attached at the back of the switch, fora push-to-wash motor.


    Hope this helps someone struggling to identify the wiper loom in one of these old lumps. Various diagrams on the Internet have conflicting or incomplete data, this article may make the job simpler. Attached .PDF for download.
  • Recent Articles

  • Recent Forum Posts

    PhilW

    Does anybody make parts for A-H jacks?

    My BJ8 jack is missing the smaller threaded rod with the tang on the top, all else is OK. Does anyone make parts for the Shelley Jacks?

    PhilW Today, 08:15 AM Go to last post
    JPSmit

    Re: 69 Sprite drum brake adjuster

    If you look at the pic you will see that the adjuster (threaded part) works like a wedge pushing the pad further apart.



    More

    JPSmit Today, 08:14 AM Go to last post
    Graham H

    Re: Gear reduction starter problems

    Dirty battery clamps.

    Graham

    Graham H Today, 07:13 AM Go to last post
    TRclassic3

    Re: Body leans to right side

    Thanks for the suggestion John. I’ll give that a go today and report back.

    TRclassic3 Today, 07:11 AM Go to last post
    Jim_Gruber

    Re: Clicking from rear

    Check and make sure your drums aren’t rubbing their edges. Rotating slowly with rear brakes adjusted correctly make sure the drum is not rubbing

    Jim_Gruber Yesterday, 11:21 PM Go to last post
  • Recent Blog Posts

    Curt Johnson

    Healey restoration

    Looking for someone to restore my A-H 3000. I believe there is a well-regarded shop in Paso Robles (or somewhere near there). Can someone give me the name, address, phone number?

    Curt Johnson 06-18-2020 12:36 PM
  • Twitter