• Recent Articles

  • Recent Forum Posts

    Joe Schlosser

    Wire wheel Parts Free to good home

    I have all the bits for a semi elliptic setup rear and front.
    everything is disassemlled and needs a good cleaning but Is all there.

    Joe Schlosser Today, 11:21 PM Go to last post
    Marvin Gruber

    Re: Clutch replacement on BJ8

    Yes sir! Plenty of meat left. Clutch pressure plate weak, would not release. Apparently cheap aftermarket. Good clutch now. Releases a good 2" from

    Marvin Gruber Today, 11:15 PM Go to last post
    Joe Schlosser

    Re: Bug Eye fuel gage sending unit

    I went with the NOS locators unit. The usual pain to drop the tank and replace.
    I did all sorts of checks to make sure it wasn't a wire or something

    Joe Schlosser Today, 11:10 PM Go to last post

    Re: Taking out the engine

    Ditto Healey Rick -

    Motor & trans out first, then brake everything else down.

    dougie Today, 10:32 PM Go to last post

    Re: Leaking 5-speed drain plug

    While not desperate, mine will need a new case. My internals are in great shape, but I'm reasonably sure the case is now junk. If your case is in good

    drooartz Today, 10:00 PM Go to last post
  • Recent Blog Posts


    MGB wire wheel problems

    I am having problems keeping the wire wheels on my MGB tight. They loosen up and make a noise that sounds like a bad universal joint. I can tighten them to make the noise go away, but they become...

    pappap50 05-14-2019 10:54 PM
  • Twitter