PDA

View Full Version : TR2/3/3A Camshaft Front Bearing Bolts



tallguylittlecar
06-13-2014, 06:15 PM
Went to install my camshaft the I just got back from TSI but I cannot seem to find a torque value in the book for the bolts that hold the front bearing to the block. What should I torque them up to?

Thanks,
Derek

charleyf
06-15-2014, 01:36 AM
If I cannot find a particular torque setting , I look up the setting a for a same sized bolt and use that. In most cases you will notice that each size bolt like 1/4" or 3/8" will most all have the same torque setting.
Charley

tallguylittlecar
06-15-2014, 07:12 AM
Charley,

Thanks for getting back to me. That was my fall back plan if there was no actual torque value.
Derek

CJD
06-15-2014, 05:23 PM
I think it's just the torque value listed for "front plate" . Perhaps I should rephrase...I hope that's it, cause that's what I used!