PDA

View Full Version : TR2/3/3A Question on TR3A hood lift assembly



TuffTR250
07-15-2013, 09:23 AM
As can be seen by the attached picture, the rod and bottom washer on my TR3A hood lift assembly are very worn. Is the rod supposed to have any grove in it, or is it supposed to be just a straight round rod? And is the bottom washer supposed to have just a plain round hole through it?
I may have to do some welding and grinding to fill the wear spots. Thanks for the help!
Regards,
Bob
28115

luke44
07-15-2013, 09:27 AM
Straight round rod. Oblong hole needs to be fixed too. I think VB sells a repro of the assembly.

TuffTR250
07-15-2013, 01:04 PM
Thanks Bruce! I think I will try welding them.
Regards,
Bob