PDA

View Full Version : Pipe Help



DNK
07-28-2011, 05:32 PM
See that pipe with the wax or something plug.

https://i123.photobucket.com/albums/o316/donkelly23/TR8/2011-06-13133915.jpg

When I had it cleaned and finished the plug washed, melted or something.
Any good ideas what to plug it with.
OD .612
ID .553

TOC
07-28-2011, 05:36 PM
Open a bottle of good wine.
Save the cork.

DNK
07-28-2011, 05:39 PM
Twice a week around here Dave.
Not quite the look I was going for

DNK
07-28-2011, 06:44 PM
Finished ,cept the pipe plug
https://i123.photobucket.com/albums/o316/donkelly23/TR8/2011-07-28160758.jpg

TFB
07-28-2011, 07:38 PM
A slight opening of the hole to 9/16 for a 3/8 npt might work,but I am not familiar with that manifold,plenum or whatever that hole is in.
Tom

DNK
07-28-2011, 07:50 PM
It's about 1/64th of an inch thick. Don't think I can tap that

TOC
07-28-2011, 08:30 PM
Okay.....no cork.
Was that part of the removed emissions control stuff? Manifold vacuum?
On US water pumps, often you will get a Corbin Clamp and a rubber cap, to cap off unused heater hose lines on the generic pumps.
I think I still have one or two around here somewhere.
Will a 1/2" or 5/8" piece of heater hose fit over it?
If so, see if your local parts place has one (looks like a rubber thimble), put a flatwasher inside to keep vacuum from pulling the end in too far, and push it on. Since no pressure, probably won't need a clamp, altho some sealer inside before you press it on would be cheap insurance.

DNK
07-28-2011, 08:36 PM
Yea , thought that too. See if I can get something that doesn't show to bad