PDA

View Full Version : TR2/3/3A TR3 wind shield



tinman58
01-09-2010, 10:01 PM
I have a nice windshield frame that I am going to have recromed. But there are six holes that the hard top would mount to. I won't have a hard top, What would be the best way to fill in the mounting holes?

Andrew Mace
01-09-2010, 10:34 PM
I'd give some consideration to a swap with someone who needs a "drilled" frame for the hardtop brackets! Alternatively, maybe some little tiny rubber plugs?

TR3driver
01-10-2010, 12:40 AM
IMO, just leave them alone. They will be hidden by the top gasket (assuming you replace it rather than reusing the one that was cut to go around the HT brackets).

angelfj1
01-10-2010, 07:14 AM
I have a nice windshield frame that I am going to have recromed. But there are six holes that the hard top would mount to. I won't have a hard top, What would be the best way to fill in the mounting holes?

Dan: not worth filling in. Leave them. You may change your mind about a hardtop and they should be covered by the rubber top-to-windscreen rubber.

tinman58
01-10-2010, 11:14 AM
Thanks Guys I will leave it as is. Didn't think of the rubber covering them up!